Howdy, Stranger!

It looks like you're new here. If you want to get involved, click one of these buttons!

Fire Resistant Gypsum Ceiling Panels





Gypsum lay-in ceiling panels are tiles which might be found in kitchens or food processing areas, storage areas, warehouses, utility rooms or any other interior or soffit ceilings that are economical and engaging as opposed to acoustical in performance. They're supported by suspended ceiling grids.

image

These gypsum panels are durable and supply cleanliness towards the food processing areas. They normally are vinyl laminated to close out dirt, moisture and odors. The vinyl surfaces are embossed and are exceptionally stain resistant. Like withstand repeated washings. Lighting efficiency is maximized since they have exceedingly reflective surfaces.

Using the laminated vinyl finish, there is no more requirement of additional finishing. However if a customer so desires, it is recommended to use two coats of alkyd or semi-shiny latex enamel. Also, an oil primer works extremely well then coated with oil paint or flat latex. Flat oil paint, two coats, can also be used.

The vinyl gypsum ceiling panels will also be authorized by the Department of Agriculture of the United States of America. The panels are cut easily and can fit in standard suspended ceiling grids. They are easily washable. Lightly rubbing the top with damp sponge or cloth using soap or detergent will remove dirt and marks. Strong organic solvent cleaners and steel wool usually are not recommended to make use of in cleansing the boards.

Detergents, 5% Nitric Acid, 10% Ammonia, Ethanol, Oleic Acid, Bleach, 10% Hydrochloric Acid, Carbon Tetrachloride, Hydrogen Peroxide, and Port Wine may have no effect on the gypsum panel even though these chemicals come across the panels all day and night. They could be easily washed with soap and water. 10% Citric Acid, Ketchup, 10% Sodium Hydroxide, Lemon juice, Coffee, Mayonnaise, Tea, Cooking oil, Milk, Trisodium Phosphate, Crayon, Mustard, and Vinegar can also get no relation to the gypsum board even when subjected to these chemicals for 24 hours. Pencil marks will leave a really light stain though. Acetone exposure for 24 hours then washed with soapy water gives the panels a shiny finish.

Gypsum lay-in ceiling panels should not be used in areas which are directly encountered with water. They should also not employed in pools, shower dressing rooms as well as in areas with high humidity or moisture. Backload ought to be limited to 0.5 pounds per sq . ft .. Enclosed or unheated spaces higher than the ceiling panels ought to be properly ventilated. Retainers or hold down clips have to be provided in installations where sudden wind or air pressure change may uplift the panels. Don't use anything but an approved suspended system for exterior use when being installed outdoors.

The gypsum boards come in 1/2" and 5/8" thick type X fire rated. A type X fire rating means that the board features a minimum fire rating of 1 hour, the actual feature most building codes. It really is more fire resistant and much more expensive compared to standard boards. Fire rated boards are usually needed in family room areas and in such areas that are at risk of fires.
More info about keo dan gach check this useful web page: learn here
Sign In or Register to comment.